The treatment process is as follows:

[zihadhosenjm40]

The places where the woodworm larvae are concentrated are determined (by sound or falling shavings). Then these areas are marked with a marker.
A long drill is used to drill holes in the wood that are at least 1/3 the thickness of the timber. Drilling is done at different angles to the surface.
The affected surface is cleaned of dirt and dust with a hungary mobile database brush. It leaves scratches on the wood, through which the antiseptic will penetrate deep into the wood, which increases the effectiveness of the treatment.
The prepared surface is treated with a foam roller impregnated with an antiseptic composition. The antiseptic is injected into the holes made with a syringe.
It is advisable to carry out the treatment in the warm season and in a well-ventilated room. Usually, no later than an hour later, you can observe the process of insect migration from the tree. If necessary, the treatment can be repeated.

Mistakes when processing wood with your own hands
Many owners of wooden houses think that if they process the wood themselves, they can save a lot on the services of specialists. This is partly true, when processing it themselves, the costs are limited only by the cost of materials.

However, home craftsmen often make a number of mistakes that professionals have to correct. As a result, the cost of processing increases significantly.

When planning to process a house made of timber or logs yourself, it is necessary to take into account and avoid the following typical mistakes:

violation of the technological process established by the manufacturer;
failure to maintain the required temperature conditions;
poor or no surface preparation;