The appropriate kit should be selected depending on the slope angle.

[zihadhosenjm40]

This arrangement facilitates the process of high-quality sealing and provides coverage without leaks;
The closer the pipe is to the ridge, the less space there is for snow and water to accumulate behind it, reducing the risk of leaks.
Attention! Condensation can form both inside and on the surface of the pipe, which leads to the formation of ice in the cold season. It damages the walls of the chimney, significantly worsening the draft and reducing the service life.

Round pipe
A roof equipped with a round chimney is one of the common options for private construction.


To ensure high-quality adhesion to the roof of such a pipe, standard three-layer structures are produced. The central part of such a multi-layer system is made of heat-insulating material. The set is supplemented with a flat steel sheet and an apron-cap, into which the chimney pipe is inserted.

Standard systems are produced for the most common angles. With the help of such structures, it is quite easy to make a high-quality connection yourself.

The abutment plate is tightly and rigidly finland mobile database on the roof plane. The top of the cap is cut off, the size of the cut should allow the pipe to pass into the hole tightly, without gaps. The upper edge of the apron is pressed against the pipe with a steel clamp with a gasket made of heat-resistant elastic material.

Attention! All materials must be sufficiently clean, as well as the roof surface. This will ensure the highest quality of sealing work.

The plate is secured with self-tapping screws, using rubber or neoprene gaskets.


If the slope angle does not allow the use of a standard type chimney system, this can be done without the involvement of specialists. To do this, to create a sealed apron, it is necessary to glue the perimeter of the pipe with lead or aluminum tape.


It is also possible to use a ready-made oval-shaped lead part, which can be easily profiled to fit a soft roof covering or a roof made of hard material using a rubber mallet or a wooden tool.

This lead self-adhesive is a material with high performance properties. It is resistant to temperature fluctuations, corrosion and ultraviolet radiation.